Synchronising The Electronic Control Unit With The Radio Remote Hand Set; Conformity Declaration; Technical Data - Truma Mover SR Instructions De Montage Et Mode D'emploi

Synchronising the electronic control unit with
the radio remote hand set
The remote hand set and the control unit are
synchronised with each other in the factory.
If the control unit or the remote hand set is replaced, they
must be re-synchronised as described below.
Check that the assembly has been carried out as specified in
the installation instructions and that the drive rollers have no
contact. Check that the battery is properly connected, check
the condition of the battery and that a voltage of 12 V is pre-
sent at the control unit.
Press the reset button (k) on the control unit and hold down
(red LED – j – flashes slowly), and after approx. 5 seconds
the LED (j) starts to flash rapidly. Then release the reset but-
ton and press and hold down the caravan reverse button on
the remote hand set (c) within 10 seconds, simultaneously
switching on the remote hand set using the slide switch (a).
j
k
Fig. 4
The remote hand set and the control unit are synchronised to
each other. After successful synchronisation, the red LED
flashes rapidly.
16

Conformity Declaration

1. Manufacturer master data
Name:
Address:
2. Equipment identification
Model / Version:
Mover® SR manoeuvring aid
3. Complies with the requirements of the following
3.1 R&TTE directive (1999/5/EC)
3.2 EMC directive (2004/108/EC)
3.3 Radio Interference in Vehicles 72/245/EEC
3.4 Low voltage directive 2006/95/EC)
3.5 End of Life Vehicles (2000/53/EC)
and bears the type approval number e1 03 4473 and the
CE symbol.
a
Mover® SR
Class 1, frequency 868 MHz.
Countries:
c
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU,
IE, IS, IT, LT, LU, LV, MT, NL, NO, PL, PT, RO, SE, SI, SK.
4. Basis of proof of conformity
EN300220-2:2006, EN300220-1:2006 (R&TTE art. 3.2),
EN301489-1:2005, EN301489-3:2002 (EMC art. 3.1b),
EN61000-4-2:2001, EN61000-4-3:2006, EN61000-4-6:2001,
EN55022:2003 (Class B), ISO 7637-2:2004, EN60950:2001,
2004/104/EC, 2005/83/EC, 2006/28/EC, 2000/53/EC
5. Monitoring body
Federal Office for Motor Traffic
6. Information concerning position of undersigned
Signature: Mathias Venschott
Head of Climate Control
and Manoeuvring Systems
Product Centre

Technical data

Designation
Mover® SR
Area of operation
Single axle caravans with a total weight up to 2000 kg
Operational voltage
12 V DC
Current consumption
Average approx. 20 A
Maximum 120 A
Stand by consumption
< 20 mA
Remote hand set frequency
Class 1, 868 MHz
Speed
Approx. 16 cm per second (depending on weight and incline)
Weights
Approx. 34 kg (including cross actuation device)
Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Str. 12, D-85640 Putzbrunn
EC directives
(with the supplements)
Right to effect technical modifications reserved!
Putzbrunn, 22.04.2013