Assembling The Vacuum Cleaner; Cleaning The Dust Compartment - Rotel MICROCYCLONE6744CH Mode D'emploi

• ASSEMBLING THE VACUUM CLEANER

o Ensure the the vacuum is switched off and disconnected from the mains supply be-
fore assembling.
o Insert the hose connector onto the socket on the main body of the cleaner until it
clicks into position.
o Insert the suction tube into the floor head.
o Fit the other end of the telescopic suction tube into the handle.
o Unwind the mains cable and plug it into a socket. Never pull the cable further than
the yellow mark.
o Press the ON/OFF switch to start vacuuming.
o Adjust the power regulation knob to suit the type of flooring being cleaned.
o By opening the suction power control on the handle, you can lower the power of the
suction for more delicate jobs.

• CLEANING THE DUST COMPARTMENT

o Press the button on the suction hose connection and pull it off in a forwards direction.
Lift the bin out of the vacuum cleaner (A). Hold the bin over a container for waste
o
and/or rubbish.
o When you press the the PUSH button (B), the cover under the bin will open up.
o Dispose of the dust that has collected in the bin with great care into your own con-
tainer for waste/rubbish. Push the cover shut again.
o Clean the bin from time to time with water and a mild soap. Make sure that it is
thoroughly dried before its next use.
CAUTION: You must remove the motor filter (D) before cleaning with water.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
27