Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 346XP Manuel D'utilisation

Recommended cutting equipment for Canada
The following cutting attachments are approved for the models Husqvarna 346XP, 346XPG, 346XP E-tech, 346XPG E-
tech, 353, 353G, 353 E-tech and 353G E-tech.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and
Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.

Bar and chain combinations

The following cutting attachments are approved for the models Husqvarna 346XP, 346XPG, 346XP E-tech, 346XPG E-
tech, 353, 353G, 353 E-tech and 353G E-tech.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
0,050" H30 H22
0,058" - H25
Saw chain filing and file gauges
40 – English
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
1,3 10T
1,3 10T
1,3 10T
1,3 10T
1,3 10T
1,5 10T
1,5 10T
1,5 10T
1,5 10T
1,5 12T
Chain
Type Drive link count
Husqvarna H30 56
64
66
72
78
Husqvarna H25 56
64
66
72
78