Bose FreeSpace DS 40SE Guide D'installation page 23

U.S. ONLY • KUN USA • NUR USA • SÓLO EE UU • ÉTATS-UNIS UNIQUEMENT • SOLO USA • ALLEEN VS • ENDAST USA
With standard steel 4" x 4"
junction box
The FreeSpace ® DS 40SE loudspeaker can be mounted directly on
standard U.S. steel 4" x 4" junction boxes. There may be several
junction boxes available that are compatible with the FreeSpace DS
40SE wall mount bracket, but Bose Corporation only recommends
the junction boxes it has validated.
U.S. 4" x 4" Standard Steel Junction Boxes
Approved by Bose
Manufacturer:
Steel City
Installation Type: Wooden Stud
Catalog Number
52151-V-1/2 & 3/4
Installation Type: Metal Stud
Catalog Number
52151-CV-1/2 & 3/4
Please check pro.Bose.com for an up-to-date list of
Bose validated junction boxes.
Mounting the Bracket
Manufacturer:
Raco
235
8235
237
Bose ® DS Trim Plate (accessory)
• It is the responsibility of the installer to properly install junction
boxes to ensure the safety of the loudspeaker installation. Consult
a building professional for the proper junction box installation
methods before installing the loudspeaker.
• The junction box should be installed in such a way that it is
structurally capable of supporting the weight of the loudspeaker.
A 10:1 safety weight ratio is recommended.
• Failure to properly install a junction box or loudspeaker could
result in damage, injury, or death.
• Use #8-32 x 2" truss head screws (4) included with the accessory
Bose DS Trim Plate.
23