Place a container with a capacity of
9.
at least 1.0 l under the outlet system
and confirm.
The programme runs.
Duration: approx. 19 minutes
Info: If there is not enough descaling
solution in the water tank, you will be
asked to: Refill with still water and
confirm.
Rinse out the water tank and (if
10.
removed) re-insert the water filter.
Pour in fresh still water up to the
11.
"max" marking and re-insert the
water tank.
The programme runs.
Duration: approx. 7 minutes
Empty the container and confirm.
12.
Empty the drip tray and re-insert.
13.
Fault table
Problem
Coffee or milk froth quality var-
ies considerably.
No hot water dispensed.
Too little or no milk froth.
No intake of milk is performed
by the milk system.
Cause
Build-up of limescale in the
appliance.
The milk system or the intake
of the milk system is soiled.
The milk system or the intake
of the milk system is soiled.
Unsuitable milk.
Build-up of limescale in the
appliance.
The milk system is incorrectly
assembled.
Incorrect connection sequence
for milk container and milk sys-
tem.
Empty, clean and re-connect the milk
14.
container.
The programme has finished. The
appliance is ready for use again.
Press the $/± button to exit the
15.
programme.
3
Trouble shooting
Faults often have simple explanations.
T r o u b l e s h o o t i n g
Before calling the customer service,
please refer to the fault table and
attempt to correct the fault yourself.
Please read through the safety
information at the beginning of these
instructions.
Remedial action
Descale the appliance in accordance
with the instructions.
Clean the milk system or the intake.
~ "Cleaning the milk system"
on page 59
Clean the milk system or the intake.
~ "Cleaning the milk system"
on page 59
Do not use milk that has already been
boiled. Use cold milk with a fat content
of at least 1.5%.
Descale the appliance as described in
the instructions.
Correctly assemble all parts.
~ Fig. #
Connect the milk system to the outlet
system first, then connect the milk con-
tainer.
Trouble shooting en
63