Siemens TI 905 Série Mode D'emploi page 65

Masquer les pouces Voir aussi pour TI 905 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Water dripped onto the inner
floor of the appliance when the
drip tray was removed.
The drip tray cannot be
removed.
The outlet system cannot be
assembled or disassembled.
Display shows "Fill bean con-
tainer". Display appears
although the bean container
)B is already full, or the
grinder is not grinding any cof-
fee beans.
Display shows: "Empty drip
tray" even if the drip tray is
empty - what to do?
Display shows "Refill with still
water or remove filter"
Display shows "Clean brewing
unit".
If you are unable to solve the problem, always call the hotline.
You will find the telephone numbers at the back of these instructions
--------
Drip tray removed too early.
The coffee grounds container is
very full.
The coffee grounds slider
becomes stuck.
Incorrect sequence
Beans are not falling into the
grinding unit (beans too oily).
Emptying is not detected when
the appliance is off.
The drip tray is soiled.
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Brewing unit is soiled.
Too much ground coffee in the
brewing unit.
The brewing unit's mechanism
is stiff.
Trouble shooting en
Wait a few seconds after the last drink
was dispensed before removing the
drip tray.
Clean the interior of the brewing unit.
~ "Cleaning the brewing unit"
on page 60
Correctly insert the coffee grounds
slider.
Connect the outlet system (with milk
system) first, then connect the milk sys-
tem; alternatively, in the case of disas-
sembly, first remove the milk container
and then remove the outlet system.
Gently tap the bean container. Change
the type of coffee if necessary. When
the bean container is empty, wipe it
with a dry cloth.
When the appliance is switched on,
remove and re-insert the drip tray.
Clean the drip tray thoroughly.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter in water until
no more air bubbles escape; insert the
filter again.
Insert a new water filter.
Clean the brewing unit.
Clean the brewing unit. Add no more
than two level measuring spoons of
ground coffee.
Clean the brewing unit. ~ "Daily care
and cleaning" on page 58
65

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ti 907 sérieTi 909 série

Table des Matières