Inserting/Extracting The Second Lens; Inserting/Exchanging Gobos - Futurelight EVO-COLOR 250 Mode D'emploi

Inserting/Extracting the second lens

You can adjust the radiation angle by inserting or extracting the second lens.

Inserting/Exchanging gobos

If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
DANGER!
Install the lens with the device switched off only.
Unplug from mains before!
The second lens is located in the device's interior with a radiation angle of
30°. If the second lens is removed, the radiation angle changes to 19°.
For extracting or inserting the second lens, please follow the instructions
given below:
Carefully unscrew the four housing screws with an appropriate screwdriver
and remove the housing cover. Unscrew the knurled-head screw in the
interior and extract or insert the second lens. Insert the lens in the
lampholder (illustration 3) if not required. Tighten the knurled-head screw.
Replace the housing cover and tighten the housing screws.
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
Slot-in gobo-system for exchanging gobos without tools!
Inserting/Exchanging gobos as described above.
Notes!
36/100 51840870_V_1_0.DOC