Lamp Adjustment; Inserting/Exchanging Gobos - Futurelight PHS-575 Mode D'emploi

Lamp adjustment

"Push" the lamp out by turning the screws „1, 2, 3" counterclockwise ¼-turn at a time the light is bright and
evenly distributed.

Inserting/Exchanging gobos

If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Please note:
Pay special attention to the direction of the lamp when inserting the lamp.
The lamp features a notch (1) on one side of the socket. This notch must be
directed towards the fixation plate (2) of the lamp holder as shown in the
illustration to the left.
Remove the holding mechanism on the left side of the lamp holder, press
the other end of the lamp into the socket of the lamp holder.
Make sure that the notch is oriented towards the fixation plate of the lamp
socket.
Do not operate this device with opened cover!
The lampholder is aligned at the factory. Due to differences
between lamps, fine adjustment may improve light performance.
Strike the lamp, open the shutter, set the dimmer intensity onto
100 % and direct the light towards a flat surface (wall). Center
the hot-spot (the brightest part of the beam) using the 3
adjustment screws „1, 2, 3" Turn one screw at a time to drag
the hot-spot diagonally across the projected image. If you
cannot detect a hot-spot, adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three screws
„1, 2, 3" clockwise ¼-turn at a time until the light is evenly
distributed.
If the light is brighter around the edge than it is in the center, or
if light output is low, the lamp is too far back in the reflector.
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
40/117 00024314.DOC, Version 1.5