Futurelight EVO-COLOR 250 Mode D'emploi page 47

- Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
• Select "MIC" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm; the display shows "M-70".
• Press [UP] to select the desired sensitivity.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Auto run if no DMX
With this function, you can set the device to auto run if no DMX-signal.
• Select "AUTO" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Music control if no DMX
With this function, you can set the device to sound-controlled program-run if no DMX-signal.
• Select "SOUN" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Adjust ventilation fan
With this function, you can adjust the ventilation fan.
• Select "FANS" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm; the display shows "AUTO".
• Press [UP] to select "HIGH" or "AUTO".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Rest
- Reset
With this function you can Reset the device via the Control Board.
• Select "REST" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the
default values (shaded). Any edited scenes will be lost.
• Select "LODA" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Ver
- Software version
With this function you can display the software version of the device.
• Select "VER" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-1.0",
"V-2.6".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 3
47/100 51840870_V_1_0.DOC