Lamp Adjustment; Inserting/Exchanging Gobos - Futurelight DJ-HEAD 250 SPOT Mode D'emploi

Pro-head-spot
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Lamp adjustment

The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp and focus the light on a flat surface (wall). As the optimum distance of lamp from lens was
adjusted during the installing or changing the lamp (by turning the screw "A"), it is necessary to adjust only
the second position by turning the screw "B", in order to center the hot-spot (the brightest part of the beam).
If the Hot Spot seems to be too bright, you can lower its intensity by moving the lamp closer to the reflector.
Do so by turning srew "A" until the light is evenly distributed.
If the light on the edge seems to be brighter as in the center, the lamp is too close at the reflector. In this
case, you need to move the lamp away from the reflector until the light is evenly distributed and the beam
appears bright enough.

Inserting/Exchanging gobos

DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
Notes!
Slot-in gobo-system for exchanging gobos without tools!
Inserting/Exchanging gobos as described above.
27/68
00025523.DOC, Version 1.2

Publicité

Table des Matières
loading

Table des Matières