AVG DAKOTA-AVD-306PSB Instructions D'installation Et Guide De L'usager page 23

INSTALLING THE MICRO-MESH FILTERS
To install filters for the following four steps:
1- Angle the filter into slots at the back of the hood.
2- Push the button on handle of the filter.
3- Release the handle once the filter is into a resting position.
4- Repeat to install all filters.
LED LAMP REPLACEMENT
WARNING
NOTE : Before changing the lights, make sure that the appliance is unplugged.
Protect your hands by wearing gloves to avoid injuries.
Replacing the LED lamps:
1.Switch off the unit
2. Unscrew the outer glass frame panel with a screwdriver
3. Pull out the light wire, disconnect the light wire and take down the outer glass frame panel
4.Unscrew the lamp mounting bracket
5.Replace the defective lamp.
6.Reconnect the light wire and assemble the outer glass frame panel.
:
23