Publicité
Les langues disponibles
Les langues disponibles
ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels for deepcut, adjust cutting height to suit your requirements. Medium
position is best for most lawns
MOWING TIPS
• Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce
pushing effort and to keep from overloading the engine and leaving clumps of grass clippings. It may also be
necessary to re-duce ground speed and/or run the lawn mower over the area a second time.
For extremely heavy cutting, reduce the width of cut by over lap ping previously cut path and mow slowly.
• Pores in cloth grass catchers can become filled with dirt and dust with use and catchers will
collect less grass. To prevent this, regularly hose catcher off with water and let dry before using.
• Keep top of engine around starter clear and clean of grass clippings and chaff.
This will help engine air flow and extend engine life.
MAINTENANCE
IMPORTANT - Regular, careful maintenance is essential for keeping the safety level and original
performance of the machine unchanged in time.
1）For the gasoline engine maintenance, Please read engine manual.
2) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Regular
maintenance is essential for safety and performance.
Never store the equipment with fuel in the tank inside a building where fumes can reach a open flame or a spark
or a source of extreme heat.
3)Allow the engine to cool before storing in any enclosure.
4)To reduce the fire hazard, keep the engine; exhaust silencer, battery compartment and petrol
storage area free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings
in rooms.
5)Replace worn or damaged parts for safety ,For reasons of safety, do not use the equipment with worn or
damaged parts. Parts are to be replaced and not repaired. Parts that are not of the same quality can damage the
equipment and be dangerous for your safety.
14)If the fuel tank has to be drained, this should be done outdoors and when the engine is cool.
15)Wear strong work gloves when removing and reassembling the blade.
16)Check the blade's balance after sharpening.
17)Check the self-closing guard and grass-catcher frequently for wear and deterioration.
10)Whenever the machine is to be handled, transported or tilted you must:
- wear strong working gloves;
- grasp the machine at the points that offer a safe grip, taking account of the weight and its distribution.
CLEANING
Carefully clean the machines with water after each cut; remove the grass debris and mud accumulated
inside the chassis to avoid their drying and thus making the next start-up difficult.
The paintwork on the inside of the chassis may peel off in time due to the abrasive action of the cut
Publicité
