Télécharger Imprimer la page

Gardeo GTDTAC58HP65T-BSM3R Manuel D'utilisation page 23

Publicité

Les langues disponibles

Les langues disponibles

Instruction for grass bag assembly
1. Put out the grass box and metal bracket from the packing box
2. Put the metal bracket into the grass box, keep the handle outside.
3. Fix the plastic jacket in the metal bracket.
Operation
Brake lever –must be held down to the handle to start the engine. Release to stop the engine.
Starter handle - used for starting engine.
Drive control lever - used to engage
Power-propelled forward motion of lawn mower.
Range of application
①.Cutting up and depositing the grass on the lawn
.Cutting up and collected in the grass catcher(suitable to YH58BSHC)
.Cutting up and ejecting backwards(suitable to YH58BSHC)
.Cutting up and ejecting sidewards. (suitable to YH58BSHC,YH58BSCH,YH58BSC)
Mulching
1. Installation and removal of the accessories must always be take place with switched off engine.
2. Please make sure the stability of the attached mulching accessories after installing.
3. For mulching plate, you only allowed use the accessories from original factory
4. Always avoid clearing away an excessive quantity grass so that the mower mechanism and the engine are
overloaded. It will helpful to pass excessive grass if reduce the speed of self-propelled.
Assembly
Put the baffle plate and raises (1), aim at the (2)
Disassembly
Press the (3) tightly by thumb in the center, then loose and deflect direction take down the mulching plate.
Hang up the grass catcher
Raise the baffle plate and hang up the grass catcher in the illustration shown.
round hole underside, fax up the
DRIVE CONTROL
• Self-propelling is controlled by holding the operator
presence control bar down
to the handle and pushing the drive control lever
forward until it clicks; then
releasing the lever.
• Forward motion will stop when the operator presence
control bar is re leased.
To stop forward motion without stopping engine, release
the operator presence
control bar slightly until the drive control disengages.
Hold operator presence
control bar down against handle to continue mowing
without self-propel ling.
autolocking hook engage

Publicité

loading