Güde MBS 1100 Traduction Du Mode D'emploi D'origine page 16

ENGLISH
16
Putting into operation for your safety
Before carrying out any work on the machine,
disconnect the plug from the socket.
Bei unbeabsichtigtem Betätigen des Ein-/Ausschalters
besteht Verletzungsgefahr.
Assembly
Pull out the ratchet (pic. 1)for uncovering.
Length stop:
Screw the guide rail to the thread and fixate the
length stop by the screw (pic.12)
Before putting the device into operation
The working surface and area must be sufficiently lit
at all times.
Put the device on a flat, horizontal surface and check
the device if stable. Do not place the device on wall.
There must be no person in the dangerous area.
The minimum safety distance of 10m must be
respected.
Saw band
Unplug the device before any adjustment and
servicing!
Saw band stretching:
Stretch the saw band using the stretching bolt (pic.
15). The saw band is stretched correctly when it can
be pressed by 2-3 mm.
Guide adjustment:
The saw band guide must be adjusted as, otherwise,
it could get flipped over, which would result in an
unclean cut.Loosen the bolt (pic. 15/1) and adjust the
guide depending on the width of the material to be
processed.
Changing the saw band:
Loosen the saw band. Loosen the bolt and remove
the cover. Now fit in a new saw band on the rollers
and place it between the guide bearing and the band
guide. Then, stretch the saw band again and close the
covers safely and firmly.
Operating the device
Angle adjustment:
Adjust the angle to the material to be processed at all
times. To shift the entire work block, loosen the bolt
(pic. 13/1). Using both stops, precise adjustment of 0°
+45 is possible (pic. 13/2a).
Cutting speed:
The cutting speed always depends on the material
being cut. Speed can be changed by turning the knob
(pic. 16).
Maintenance
Before carrying out any work on the machine,
disconnect the plug from the socket.
The machine must not be used under any circum-
stances if the machine or the safety devices are
damaged.
If the device is defective, the repair has to be made
exclusively by the customer service.Use only original
accessories and original spare parts.
Only a regularly maintained and treated appliance
can serve as a satisfactory aid. Insufficient mainte-
nance and care can lead to unforeseen accidents and
injuries.
Daily maintenance:
Removal of cuts
Saw band check
Check of all the protective equipment
Weekly maintenance:
Thorough device cleaning, removal of cuts
Cleaning of saw rolls and saw roll supporting surface
Monthly maintenance:
Check the fixing bolts of the saw rolls
Check the gear fixing bolts
Guarantee
Warranty period of 12 months applies to commercial
use and 24 months applies to private use and com-
mences on the day of purchase of the device.
The guarantee solely covers inadequacies caused
by material defect or manufacturing defect. Original
payment voucher with the sales date needs to be sub-
mitted for any claim in the guarantee period.
The guarantee does not cover any unauthorised
use such as appliance overloading, use of violence,
damage as a result of any unauthorised interference
or caused by foreign items. Failing to follow the
operating and assembly instructions and common
wear are
Service
Do you have any technical questions? Any claim? Do
you need any spare parts or operating instructions?