Sincro DC Série Manuel D'utilisation Et De Maintenance page 17

DC SERIES
CONTENTS
1. SAFETY RECOMMENDATIONS
2. INTENDED USE
3. INTRODUCTION
3.1 Control of ID plate
4. OPERATING PRINCIPLE AND
CHARACTERISTICS OF VOLTAGE REGULATION
SYSTEM
5. GENERAL MECHANICAL AND ELECTRICAL
SPECIFICATIONS FOR COUPLING
WITH ENGINE
6. INSTALLATION
6.1 Lifting
6.2 Mounting on engine
6.2.1 Assembly format SAE
6.2.2 Assembly format IM35
6.2.3 Dismantling
6.2.4 Tightening torques
6.3 Connections and earthing
6.4 Preliminary controls
6.4.1 Control of electrical insulation
6.4.2 Control of voltage
6.4.3 DBC1 AVR settings
6.4.4 Initial start-up
7. AFTERSALES ASSISTANCE AND MAINTENANCE 25
7.1 Control and check procedures
7.1.1 Control of windings and electrical insulation 25
7.1.2 Control of the rotating rectifier diodes (FB
DC, IB DC)
7.1.3 Brushes and collector (E3 DC, FT DC)
7.1.4 Control of bearings
7.2 Removal and replacement of components and
component assemblies (FB DC, IB DC)
18 7.2.1 Replacing the bearings
7.2.2 Removal of the main rotor
19 7.2.3 Removal of the rectifier diodes
7.2.4 Removal of the fan
19 7.2.5 Removal of the rotor exciter
19 7.3 Troubleshooting
8. CLEANING AND LUBRICATION
19 9. DISMANTLING AND DISPOSAL
10. SPARE PARTS AND AFTERSALES
10.1 Aftersales procedure and contact addresses 29
19 10.2 Shipment
20 11. WARRANTY
20
20 APPENDIX A
21 Resistances and electrical data
APPENDIX B
21
22 Wiring diagrams
22 Connection diagrams
22 APPENDIX C
22 Exploded views and Spare parts list
22 APPENDIX D
23 E3 DC and FT DC Declaration of Incorporation
23 FB DC and IB DC Declaration of Incorporation
24
25
25
25
26
26
26
26
26
26
28
27
27
29
29
29
17