Sharpening/Replacing The Blade; Adjusting The Carburettor; Storage; General Storage Instructions - Grizzly BRM 4616-20 HA Traduction De La Notice D'utilisation Originale

UK

Sharpening/Replacing the Blade

• Take off the spark plug and check the
blade for wear and damage.
• Always have a blunt blade resharp-
ened by a specialist workshop, as an
imbalance check can be carried out
there.
• Always have a specialist workshop
change a damaged or imbalanced
blade. Incorrect installation can result
in serious injury.

Adjusting the Carburettor

The carburettor has been preset in the
factory for optimum performance. If read-
justments are required, have the adjust-
ments made by a specialist workshop.

Storage

General Storage Instructions

Do not store the equipment
with a full collection box. In hot
weather, the grass begins to fer-
ment when heat is generated.
Risk of fire.
• Clean and service the equipment be-
fore storage.
• Allow the engine to cool before storing
the equipment in enclosed areas.men
abstellen.
• Use suitable and authorised contain-
ers for storing fuel.
• Keep the equipment in a dry place
that is protected from dust and out of
reach of children.
• For space-saving storage, the upper
handle bar can be folded down (see
small image
nuts and fold down the handle bar so
86
) Release the top wing
the equipment takes up less space.
The Bowden cables must not be
squashed when doing this.
• Do not wrap the equipment in nylon
bags as damp and mould could form
Storage During Longer Breaks
from Operation
Non-observance of the storage
instructions may cause starting
problems or permanent damage
as a result of fuel residues in the
carburettor.
• Empty petrol tank in a well-ventilated
place.
• Empty carburettor: For this purpose,
start motor and leave it running until
the motor stops. Let motor cool down.
• Change the oil (see "changing the en-
gine oil ").
• Preserve the engine:
- Unscrew the spark plug (see "clean-
ing and maintenance" - Change/
adjust spark plug;
- Pour a tablespoon of engine oil
through the spark plug hole into the
engine compartment;
- Pull the starter cord slowly several
times with the safety catch pulled in
order to distribute the oil inside the
engine;
- Screw the spark plug tight.
• Dispose of used oil and petrol resi-
dues in an ecofriendly manner (see
"disposal / environmental protection").
There is no need to drain the petrol
tank if a fuel stabiliser is added to
the petrol.