The Transmitter From Below - Multiplex Cockpit SX 7 Mode D'emploi

4. Operating elements
The following operating elements can be found on the
left hand side:
a. 2-position switch CS/A-Red
(switch for Combi-Switch/Autorotation)
b. Teacher-Vario button for trainer mode and status enquiry
c. Aux 5 - free 3-position switch (COCKPIT SX 12 only)

5. The transmitter from below

The housing of the COCKPIT SX is screwed together and does
not have to be opened to adjust the spring tension of the stick
or to define the throttle stick.
Adjusting screws for the right stick
a. Deactivate tension spring on the stick (stick centring)
b. Adjust stick ratchet
c. Adjust stick sensitivity
Adjusting screws for the left stick
d. Deactivate tension springs on the stick (stick centring)
e. Adjust stick sensitivity
f. Adjust stick ratchet
The appropriate adjusting tool can be found in the left com-
partment, below the loudspeaker.
Important: loosen/tighten screws carefully!
Turn the stick adjusting screws carefully and don't unscrew
them too far, if you want to reverse your adjustments for stick
centring, ratchet or stiffness again. Otherwise, the screws
could press against the base of the transmitter on the inside.
Deactivate the stick centring spring as follows:
Turn screw a (right stick) or d (left stick) clockwise until the
stick no longer springs back even at its most extreme position.
The following operating elements can be found on the
right hand side:
a. 3-positions switch Phase/Aux 2
(for flight phases or as a free 3-positions switch
b. T-Cut (EMERGENCY-throttle-CUT button)
c. Aux 6 - free 2-position switch (COCKPIT 12 only)
The following operating elements can be found on the
back:
a. Rotary knobs for spoilers or throttle limiter (T-LIMIT)
b. Rotary knobs for FLAP/Aux 1
The screws can be reached through openings in the base of
the transmitter. The following diagram shows the positions of
the various adjusting screws.
Adjusting the ratchet:
Turn screw b (right stick) or f (left stick) clockwise until the
strength of the ratchet corresponds with your perceptions.
Adjusting the stiffness:
Turn screw c (right stick) or e (left stick) clockwise until the
stiffness corresponds with your perceptions.
The touchscreen pen for operating the display can be found in
the slot at the bottom on the right, as shown in the diagram
under section 5.

29