Screen Lock - Multiplex Cockpit SX 7 Mode D'emploi

9. Main menu
7. Clock symbol: Timer menu
Here you can set up both timers.
a) Timer 1
measures the actual motor run time (provided
that the throttle control has previously been
selected).The timer only runs when the control
value exceeds the set switching threshold.
b) Timer 2
measures the total flight time; it starts when
the switching threshold is exceeded, and can
only be stopped by pressing "STOP" a second
time.
In the corresponding Timer menu you can define the
transmitter control for Start, together with the associated
ON position or switching threshold.
If you have defined a flight time / motor run time, the timer
counts backwards (down) when started. An alarm sounds
when the preset time has elapsed, after which the timer
continues to count into negative values.
If you set 00:00 as time, then the timer counts upwards
with no alarm.
The output of the current timer value can either be started
using your choice of switch, or by swiping within the Timer
Status display.

10. Screen lock

The COCKPIT SX features a screen lock, which can be activa-
ted and disabled in any of the five Status displays by holding
a free area of the touch-screen pressed for three seconds.
· An active screen lock is confirmed by disabling of the main
menu knob and a descending beep.
· A disabled screen lock is confirmed by activation of the main
menu knob and a rising beep.
8. Speedometer symbol: Telemetry
Setting the telemetry data
· Sensor address 0..3 or 4..7
Here you can change the sensor names in the menus and
select which data you want to have displayed and
which data you want to have announced.
· Vario
At this point you can alter the Vario address and volume.
· Warning LED confirmation
This is where you switch off the warning LED for voltage
and residual capacity ('fueltank' display) if an alarm has
been triggered.
· Speech / Interval
At this point you can adjust the volume of speech output
and the time interval between the repeat and the output.
It is possible to pre-select the telemetry output status
by pressing the Telemetry symbol in the Status display, or
alternatively by pressing the Teacher / Vario button.
9. Persons symbol:
Teacher / Pupil / Simulator mode
For more information please refer to the
section entitled "Teacher / Pupil".
While the screen lock is active it is still possible to switch Sta-
tus displays and Telemetry output, but all other operating fields
are blocked to prevent accidental operation.

35