Publicité
Les langues disponibles
Les langues disponibles
9.5. Remote Control Mode (P 1530 / 1560)
There are two methods for remote control of current and voltage adjustment. Both methods require
current remote control part to be set up in order for remote control mode to be functional, otherwise
unit will be in CC mode all the time.
Method A:
Using two external variable DC voltage sources.
PIN
1
2
3
4
5
6
7
8
Check the output voltage range of the power supply by varying the external voltage source.
Short circuit the main output with 8AWG (8,35mm2) wire to check the display for CC setting varying
the external voltage source.
Method B:
Using two 0-5K Ohm variable resistors
Remark: variable resistors 5KOhm
PIN
1
2
3
4
5
6
7
8
Check the output voltage range of the power supply by adjusting the 5Kohm variable resistor. Short
circuit the main output with 8AWG (8,35mm2) wire to check the display for CC setting by adjusting the
variable resistor.
Function
Internal DC +5V
Voltage Adjust
Current Adjust
Ground
Output OFF
N.A.
N.A.
N.A.
Function
Internal DC +5V
Voltage Adjust
Current Adjust
Ground
Output OFF
N.A.
N.A.
N.A.
-38-
Remarks
Less the 50mA
0 ~ 5 V
0 ~5 V
Short to Ground
Remarks
Resistor end
Variable part of resistor V
Variable part of resistor
Another resistor end
Short to Ground
Publicité
