Publicité
Les langues disponibles
Les langues disponibles
1. Safety Precautions
This product complies with the requirements of the following European Community Directives:
2004/108/EC (Electromagnetic Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-Marking).
To ensure safe operation of the equipment and eliminate the danger of serious injury due to short-
circuits (arcing), the following safety precautions must be observed.
Damages resulting from failure to observe these safety precautions are exempt from any legal claims
whatever.
Do not use this instrument for high-energy industrial installation measurement.
Prior to connection of the equipment to the mains outlet, check that the available mains voltage
corresponds to the voltage setting of the equipment.
Connect the mains plug of the equipment only to a mains outlet with earth connection.
Do not place the equipment on damp or wet surfaces.
Do not cover the ventilation slots of the cabinet to ensure that the air is able to circulate freely
inside.
Do not insert metal objects into the equipment by way of the ventilation slots.
Do not place water filled containers on the equipment (danger of short-circuit in case of knock over
of the container).
Do not exceed the maximum permissible input ratings (danger of serious injury and/or destruction
of the equipment).
Do not exceed maximum load ratings of 40 A (P 1525), 30 A (P 1560), 60 A (P 1530) or 20 A (P
1535), otherwise it may damage the power supply.
Never use the power supply for the load requiring higher current than the designed value
otherwise it may damage the power supply.
Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or fuse
holding.
To avoid electric shock, do not operate this product in wet or damp conditions. Conduct measuring
works only in dry clothing and rubber shoes, i. e. on isolating mats.
Never touch the tips of the test leads or probe.
Comply with the warning labels and other info on the equipment.
Do not subject the equipment to direct sunlight or extreme temperatures, humidity or dampness.
Do not subject the equipment to shocks or strong vibrations.
Do not operate the equipment near strong magnetic fields (motors, transformers etc.).
Never short the remote sensing terminals.
Keep hot soldering irons or guns away from the equipment.
Use caution when working with voltages above 35 V DC or 25 V AC. These Voltages pose shock
hazard.
Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or
solvents.
The power supply is suitable for indoor use only
Do not operate the power supply before the cabinet has been closed and screwed safely as
terminal can carry voltage.
Do not store the power supply in a place of explosive, inflammable substances.
Do not modify the equipment in any way
Do not place the equipment face-down on any table or work bench to prevent damaging the
controls at the front.
Opening the equipment and service – and repair work must only be performed by qualified service
personnel
Measuring instruments don't belong to children hands.
-22-
Publicité
