9.3. Remote Control (PeakTech 1530/1560)
You can use the voltage and current remote control at the same time or separately.
Set up the provided remote connector plug.
a.) Remove the black portion of the remote control connector plug by removing the screw.
1.
Remove the screw
2.
Rotate the black portion
3.
Black portion / silver portion
b.)
Solder 3 wires 22AWG (0,33m
c.)
Make sure the load is disconnected and the power supply is OFF.
d.)
Plug the remote connector plug into the remote control terminal of the power supply.
e.)
Secure the remote connector plug to the terminal socket by locking connector ring.
Then, you can choose either method A or B below to use the remote control feature:
2
) to PORT 1, 2 & 4 of black portion.
Outer ring
-34-
Port numbers are
marked on the black
portion.