PeakTech 1525 Instructions D'utilisation page 32

7. Using the power supply
1. This series has 4 models. Make sure you have used the correct one. They have different output
voltage range and current as following:
Model Number
®
PeakTech 1525
®
PeakTech 1530
®
PeakTech 1535
®
PeakTech 1560
2. Make sure the Mode Switch (8) is at Normal Position. (9) P 1530
3. The power supply will perform a series of self checks when it is switched on. The LED and other
indicators on the front panel will be on by turn. When the cooling fan is being checked, a high
speed wind noise can be heard.
4. After the self checks, the CV, V and A LED indicators are lit up displaying voltage and 0.0
current. To find out about the set CC current level, just turn the current control knob one click in
either direction. The current display returns to 0.0 after a few seconds.
Below table to show the self test sequence
Self test display and Sequence
Output Voltage Range
1 – 16 V
1 – 32 V
Total Rated Current
0-40 A
0-60 A
0-20 A
0-30 A
Test contents
To show software version
Segment check
C.V. Indicator check
C.C. Indicator check
Rear control indicator check
Return to C.V.
Start to check
Over voltage protection check
Over load protection check
Over temperature protection check
Fan check
Output off (remote control mode)
(Remote Control Modus)
-31-