Bringing The Oven Into Operation; Setting The Clock - ETNA ECM163RVS Notice D'utilisation

Bringing the oven into operation

positioning
Place the microwave oven on a firm, flat
surface.
Make sure that there is sufficient ventilation
around the microwave oven. Keep a 30 cm
space free at the top. At the rear and sides
keep at least 7.5 cm free.
30 cm
7.5 cm
7.5 cm
7.5 cm
Do not cover the air vents.
The adjustable feet should not be removed.
Do not place the microwave oven near a heat
source.
Transmitting and receiving equipment such
as radios and televisions can affect the
operation of the microwave oven.
cleaning the microwave oven and
accessories
Remove the accessories from the combi-
microwave oven and clean the oven with a
mild cleaning agent.
Switch the hot-air function on for one hour at
230 °C (see page 13). Protective greases used
during manufacture will then be removed.
remark
When the oven is heated strongly for the first
time, it will have a 'new' smell. This is normal.
Switch the extractor hood on if necessary or
open a window.
After the oven has cooled down, clean it with
warm water.
Press the 'START/OK' button to restart the
cooking programme after the door has
been opened.
If the 'START/OK' button is not pressed
within 5 minutes of selecting a cooking
programme the programme will not start.
A beep sounds when a button is pressed.
If no beep is heard then the button has not
been pressed firmly enough.
Five beeps will sound when a cooking
programme finishes.

Setting the clock

1 Press the 'CLOCK/PRE-SET' button. Select
either 12-hour or 24-hour notation.
2 Turn the 'TIMER/WEIGHT' control knob. Set
the hours (between 0 and 23 for 24-hour
notation / between 1-12 for 12-hour
notation).
3 Press the 'CLOCK/PRE-SET' button. The
minutes-display starts to flash.
4 Turn the 'TIMER/WEIGHT' control knob. Set
the minutes (from 0-59).
5 Press the 'CLOCK/PRE-SET' button.
The time that you have set is displayed
(":" flashes). If you press 'STOP/CLEAR'
while setting the clock the previous clock
setting will be displayed.
remarks
When the microwave is connected to the
electricity supply the display will show "0:00".
1/3/5
2/4