EUROM QH1503 Manuel D'utilisation page 13

be 100 cm, certainly when there is a plastic or combustible ceiling. Maintain a distance of at
least 50 cm from side walls. Do not position the heater behind a door!
 The insulation of the heater is IP24 rated (splash proof) and therefore suitable for use in bath-
rooms. A distance of at least 1 m has to be maintained between the heater and baths, taps,
fountains, showers etc. Make sure that no jets of water can be directed at the heater and that
the heater cannot fall into the water.
 Only connect the heater to an earthed socket!
Permanent mounting:
The QH1503 is designed for installation in a permanent position and direct connection to the elec-
tricity network. For safety reasons, this installation should be fitted by an approved electrician.
Plug connection:
The QH1503 can also be connected directly to a power socket using the electric cable and plug.
Make sure that the electric cable does not hang over any (sharp) edges, does not make any sharp
angles, cannot be dragged and does not touch any hot surfaces.
Important: the electric cable and plug form a whole. Therefore, if either the electric cable or plug is
damaged they should both be replaced by an electrician. Only mount the original parts!
 When positioning and connecting the heater, make sure that your hands do not touch the heat-
ing elements. This is because traces can be left behind which, afterwards, will have a negative
effect on the radiated heat.
 For use with a plug, the following applies: do not use extension leads and do not connect any
other equipment next to the heater in the same socket!

Position the mounting bracket with the long side and 2 holes against the wall in the required
position, then mark the drill holes. Make sure that the drill holes are positioned at the same
height! Remove the bracket and drill 2 holes in the spots marked. Knock in the raw plugs, posi-
tion the bracket over the top and screw it firmly into the wall using the screws supplied.
 Place the heater over the bracket with the cord down and large holes positioned over large
holes. Screw securely using the bolts, rings and nuts supplied.
 Turn the heater to the required position. The body of the
heater can be turned to 5 positions (Small heater holes
over small bracket holes). The mid position is horizontal
to the room. The two positions which are directed up-
wards will only be used in exceptional cases and require
a greater distance to the ceiling (1 metre). Finally, the
heater has two positions which are directed downwards.
These are the standard positions. Secure the heater at
the required angle by screwing both of the small screws
into the double holes.
 The heater is now ready for use.
The QH1503 is supplied with a knob, ring and spring washer that is intended for a special model.
These parts are surplus and not intended for your model.
USE
To use the heater, if required insert the plug into the socket and pull on the pull switch. Each time
that you pull the pull switch, the heater will change to the next setting:
0 (off) > 1 (500W) > 2 (1,000W) > 3 (1,500W) > 0 etc.
You are able to view the heater's setting through the peep hole.
13