Armrest; Infusion Pole; Mayo Table Supporting Arm - Tecno-gaz KYRI Mode D'emploi

ENGLISH
06
6.1 Suction tube support
The module is attached to the KYRI chair by means of an articulated arm that can be used
to move the module into the most convenient position for the operator.
Suction tubes
The suction device is operated by removing the tube from its support.
To adjust the suction power, move the cursor on the handle of the tube holder terminal.
Disassembly: Remove the suction tubes from the couplings of the conveyor by turning and
pulling the tube attachment. Separate the suction tubes from the tube holder terminals by
turning and pulling the tube attachment.
NB: Never attempt to do the above by holding the suction tube directly.
SUCTION TUBES: use only the tubes provided and replace these with original ones.
The suction tubes must comply with the Biocompatibility Standard EN 30993-1.
Maintenance.
Regularly lubricate the suction tubes and the cursors for closing the tube holder terminals,
using silicone spray.
Cleaning the tubes.
Since different suction systems can be fitted (liquid ring, wet loop, air),
it is advisable to always disinfect the suction system observing the instructions of the
manufacturer of the suction system concerning the product and the times and methods of
use.
Sterilisation.
• Tube holder terminals: steam autoclave.
• Suction tubes: cold water sterilisation.
6.2

Armrest

Can be fitted on both the rails.
6.3

Infusion pole

The pole comes with a clamp and can be fitted on both the rails. Maximum load: 3 kg.
Complete with height-adjustable support for Vital monitor.
6.4

Mayo table supporting arm

The arm comes with a clamp and can be fitted on both the rails.
8
ACCESSORIES ON REQUEST