Maintenance; Scheduled Maintenance Table; Battery Charging - Nilfisk SC500 53 B Instructions D'utilisation

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
CAUTION!
When the Service icon
scheduled maintenance.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure

Battery Charging

Squeegee Cleaning
Brush/pad cleaning
Recovery tank and debris tray cleaning, and cover gasket check
EcoFlex system cleaning and draining
Squeegee Blade Check and Replacement
Solution Filter Cleaning
Battery (WET) fluid level check
Squeegee blade replacement
Drive and brush motor vent check and cleaning
Brush motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
Brush deck vibration-damper replacement (only for REV version)
(1) This maintenance procedure must be performed by an authorised Nilfisk Service Center.
18
INSTRUCTIONS FOR USE
appears on the display (50), contact an authorised Nilfisk Service Centre for
SC500 - 9099974000
Daily, after using
Weekly
the machine
revised 07/2017
Every six
Yearly
months
(1)
(1)
(1)
(1)
11/2014