Machine Operation (Scrubbing/Drying) - Nilfisk SC500 53 B Instructions D'utilisation

revised 07/2017

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. Lower the squeegee (29) with the pedal (8).
3. Press the One-Touch push-button (43) to lower the brush deck and start scrubbing and drying.
4. Start cleaning by manoeuvring the machine and pressing the paddle (2).
If necessary, adjust the maximum speed with the push-buttons (45).
5. Adjust the detergent flow by pressing the push-button (48) as necessary, depending on the type of cleaning to be performed.
NOTE
For the first 3 flow levels (Fig. 5), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this feature, see the Supervisor key paragraph in Maintenance chapter).
The level 0 closes the solution flow completely.
Lev.
1
Disc 0,75 cl/m
REV™ 0,38 cl/m
6. If necessary, to reduce the noise, turn on the vacuum system mute function by pressing the push-button (47).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk suggests to go near the walls with the right side of
the machine as shown in figure 6.
CAUTION!
To avoid any damage to the floor surface, turn off the brush when the machine is stationary, especially when the
extra pressure function is on.
7. At the end of the work, press the One-Touch push-button (43) to lift the brush deck. After 10 seconds, the vacuum system
turns off too.
8. Lift the squeegee (29) with the pedal (8).
11/2014
Lev.
2
1,5 cl/m
0,75 cl/m
A
INSTRUCTIONS FOR USE
Lev.
4
Lev.
3
3,0 cl/m
1,5 cl/m
Figure 5
B
Figure 6
9099974000 - SC500
Lev.
0
2,8 l/min
ENGLISH
OFF
P100858
P100845
15