Singer XL-420 Manuel D'instructions page 88

6. Deleting part of a design
7. Is there a way to increase the density of
the lettering?
The density is set to a standard value of 4/10th of mm,
which is usually the standard density used for Lettering.
The value is not editable.
8. Why does a design sometimes split up
into very small segments? One color
The machine has a certain limit of stitches that it can
accept. So what most probably happens is that these are
certain number of stitches (could possibly be only a few)
If you need to change the bobbin thread while embroidering
a design with the Endless hoop, it may be necessary in
possibly interfere with the removal of the hoop from the
embroidery unit, depending on the size of the design being
needle moves to center position temporarily, allowing you
to remove the hoop from the embroidery unit, change the
original position where you stopped the embroidery design
so that you can resume stitching.
NOTE: The needle must be raised to its highest
function.
Press the Twin needle button after the embroidery unit
button).
can now remove the hoop from the machine and
change the bobbin thread.
needle button will be lit red and the Start/Stop button
After changing the bobbin thread, reattach the hoop to
the embroidery unit. Press the Twin needle button once
where you stopped embroidering. To resume embroidery,
lower the presser foot and then press the Start/Stop
button.
86