Viscount Sonus 60 Guide De L'utilisateur page 45

User Guide
16. Rear connections.
On the back of the organ, there are various connections for making the audio connection to external
speaker systems, and the line and microphone input for use of the organ's internal amplifier.
- [EXT. +12V DC] connectors: power at +12 Volt can be obtained from these connectors to switch-
on any VISCOUNT speakers connected to the PROG. OUT. outputs.
- OUT [GEN. SUB] (General Sub-Woofer): dedicated output for the connection of low-frequency
speakers (sub-woofer).
- PROG. OUT (Programmable Outputs): the instrument's general line outputs, allowing simulation of the
wind-chests of pipe organs. The signals are distributed over the outputs on the basis of the display function
settings, which allow setting of the type of wind-chest, its size and the position in space of the speakers
used, for each stop. Each output also has dedicated level and equalisation controls.
- INPUT [L(+R)] / [R]: line inputs which allow other instruments to be played using the organ's
internal amplification. If the source is monophonic use the [L+(R)] connector only.
- INPUT [MIC]: microphone input allowing amplification of the signal from a microphone.
- [GAIN]: trimmer for regulating the gain of the input signal received at the [MIC] connector.
WARNING!
This group of connections on the rear is not visible from the outside and the organ's wooden rear
panel has to be removed to access it. Contact qualified staff for this procedure.
Sonus 60 / 60
Viscount
43
- 45 / 45 - 40 / 40
Dlx Dlx Dlx