Malfunctions; Transport And Storage; Technical Specifications - Tunturi Classic BIKE 3.0 Mode D'emploi

MALFUNCTIONS

Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary to
take the whole device in for repair, as it's usually sufficient
to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer/distributor immediately.
Always give the model and serial number of your
equipment. Please state also the nature of the problem,
conditions of use and purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number for
the part you need. The spare part list is at the back of this
manual. Use only spare parts mentioned in the spare part list.
TRANSPORT
AND STORAGE
Please follow these instructions when carrying and
moving the equipment about, because lifting it incorrectly
may strain your back or risk other accidents:
NOTE! Always switch the power off and unplug the
power cord before you start moving the equipment
around!
Stand behind the equipment. Grip the seat with one
hand and the handlebar with the other, and set your
foot on the rear support. Tilt the equipment so that it rests
on its transport wheels. Wheel the equipment to move
it, on these transport wheels. Lower the equipment while
holding on to the handlebar and remain behind the
equipment all the time.
NOTE! Transport the equipment with caution over
uneven surfaces, for example over a step. The equipment
should never be transported upstairs using the wheels over
the steps, instead it must be carried. We recommend that
you use a protective base when transporting the
equipment.
To prevent the equipment malfunctioning, store in a dry
place with as little temperature variation as possible and
protected from dust.
TECHNICAL
SPECIFICATIONS
Length
Width
Height
Weight
This product meets the requirements of the EU's EMC
Directives on electromagnetic compatibility (89/336/EEC)
and electrical equipment designed for use within certain
voltage limits (73/23/EEC). This product therefore carries
the CE label.
This product meets EN precision and safety standards
(Class HB, EN-957, parts 1 and 5).
Due to our continuous policy of product
development, Tunturi reserves the right to change
specifications without notice.
NOTE! The instructions must be followed carefully in
the assembly, use and maintenance of your equipment.
The warranty does not cover damage due to negligence
of the assembly, adjustment and maintenance instructions
described herein. Changes or modifications not expressly
approved by Tunturi will void the user's authority to
operate the equipment!
We wish you many enjoyable training hours with your new
Tunturi training partner!
8
97 cm
70 cm
129 cm
43 kg