Cleaning And Maintenance; Defects And Malfunctions - Tunturi E 35 Manuel De L'utilisateur

- Press and hold MODE button for 2 seconds to
confirm program setting.
- Press START/ STOP key to start workout.
Press START/STOP key to pause workout.
- Use RESET to go back to main menu.
H.R.C. mode.
- Use UP/ DOWN key to select workout program,
choose H.R.C. mode and press mode key
to enter next setting entry for H.R.C. mode
program.
- Use UP/ DOWN key to set age.
- Use UP/ DOWN key to select 55%, 75%, 90%
or TAG (Target H.R. _ Default 100)
- Use UP/ DOWN key to set time, press MODE
to confirm.
- Press START/ STOP key to start workout
- Use RESET, to go back to main menu.
Watt Mode.
- Use UP/ DOWN key to select workout program,
choose WATT and press MODE / ENTER key
to enter next setting entry for WATT mode
program.
- Use UP/ DOWN to set WATT target.
(default: 120Watt)
- Use UP/ DOWN key to set TIME.
- Press START/ STOP key to start workout.
Use UP/ DOW) to adjust target Watt level.
- Press START/STOP key to pause workout.
- Use RESET to go back to main menu.
Recovery
- The RECOVERY key will only be valid if pulse is
detected.
- TIME will show „0:60" (seconds) and counts
down to 0.
- Computer will show F1 to F6 after the
countdown to test heart rate recovery status.
User can find the heart rate recovery level
based on the chart below.
- Press RECOVERY key again to return to the
beginning.
F1 Outstanding
F2 Excellent
F3 Good
F4 Fair
F5 Below average
F6 Poor
Body Fat
- Press the BODY FAT key to start body fat
measurement.
- During measuring, users have to hold both
hands on the hand grips. LCD display "-" "- -"
"- - -" "- - - -" for 8 seconds until computer
finish measuring.
- LCD will display BMI and FAT %.
Body fat mode error codes
- *E-1
There is no heart rate signal input detected.
- *E-4
Occurs when FAT% and BMI result is below 5 or
exceeds 50.
Trouble shooting:
- If there is no signal when you pedal, please
check if the cable is well connected.
‼ NOTE
• When stop training for 4 minutes, the main
screen will be off.
• If the computer displays abnormally, please
re-install the transformer and try again.

Cleaning and maintenance

The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
- Clean the equipment with a soft, absorbent
cloth after each use.
- Regularly check that all screws and nuts
are tight.
- If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual parts can
occur in the equipment. In most cases, it will be
sufficient to replace the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
English
19