Storing The Machine - Stihl FS 510 C-M Notice D'emploi

English
Pull out and straighten the twisted
N
rope at the starter grip.
Hold the rope steady with the starter
N
grip.
Release the tensioning wrench and
N
rope slowly so that it winds onto the
rotor.
Remove the tensioning wrench.
N
The starter grip must locate firmly in the
guide bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
When the starter rope is fully extended it
must still be possible to rotate the rotor
at least one more turn. If this is not the
case, the spring is overtensioned and
could break.
Take one turn of the rope off the
N
rotor.
40
Installing the Rewind Starter
1
1 1
Position and line up the rewind
N
starter on the engine.
Insert the screws (1) and tighten
N
them down firmly.

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
1
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove, clean and inspect the
N
cutting attachment.
Thoroughly clean the machine.
N
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
FS 510 C-M, FS 560 C-M