Stihl FS 510 C-M Notice D'emploi page 33

If the cutting attachment rotates when
the engine is idling, refer to notes in
chapter on "Adjusting the Thottle Cable"
or have the machine serviced by your
dealer. STIHL recommends a STIHL
servicing dealer.
Attach the machine to the shoulder
N
strap.
Machine is ready for use.
N
Stopping the Engine
Depress the momentary contact
N
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
FS 510 C-M, FS 560 C-M
Other Hints on Starting
Starting for first time
Depress the throttle trigger – do not
N
press down the throttle trigger
lockout.
If engine speed increases or the cutting
attachment rotates:
Go to section "Stopping the
N
Engine".
Go to "Adjusting the Throttle Cable".
N
If the engine speed does not increase,
your machine is ready for operation.
At very low outside temperatures
Set the engine to winter operation if
N
necessary, see "Winter Operation".
If the machine is very cold (frost on
N
machine), allow the engine to warm
up in the Start } position after
starting until normal operating
temperature is reached. Warning:
the cutting attachment rotates in this
position.
At very high outside temperatures
If the engine does not start after 10 pulls
in the Start } position:
Start the engine in the Run F
N
position.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Fuel tank run until completely dry
After refueling, press the fuel pump
N
bulb at least five times – even if the
bulb is filled with fuel.
Start the engine.
N
English
31