Stihl FS 510 C-M Notice D'emploi page 40

English
Removing the Rope Rotor
7
3
Use a screwdriver or suitable pliers
N
to remove the spring clip (3) from
the starter post.
Carefully remove the E-clip (7).
N
9
Carefully remove the carrier (5) with
N
pawls (2) and washer (8) and put
them to one side so that the pawls
and washer cannot fall out.
Pull the rope rotor (9) off the starter
N
post.
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
38
If the rewind spring needs to be
N
replaced, continue with "Replacing
the Rewind Spring".
If the starter rope needs to be
N
replaced, continue with the
following chapter-
Replacing the Starter Rope
Pry the cap out of the starter grip.
N
Remove worn rope or remaining
5
N
rope from the rotor and starter grip.
2
8
Thread the new rope through the
N
starter grip and tie a simple
overhand knot in its end as shown.
Pull the knot back into the grip.
N
Refit the cap in the grip.
N
10
Thread the rope through the top of
N
the guide bushing (10) and rope
rotor (9).
Tie a simple overhand knot in the
N
end of the rope.
Pull the knot into the rope rotor – if
N
necessary, push the knot into the
rotor's recess.
Go to "Installing the Rope Rotor".
N
FS 510 C-M, FS 560 C-M
9