Automatic Boost Function - Pelgrim IDK264ONY Notice D'utilisation

OPERATION
10

Automatic boost function

01
02
EN 14
Setting the kitchen timer
1. Touch the timer display (10) .
Make sure that all the cooking zones are switched off.
2. Use the slide control to adjust the desired time.
First set a value in the right display and wait until the figure no
longer flashes and a dash appears in the left display. Then set
the left display (if a preset time longer than 9 minutes is required).
An alarm signal will sound once the set time has elapsed.
Press the slide control (02) to switch off the signal.
All cooking zones are equipped with an automatic boost function. If the
automatic boost function is activated, the cooking zone will automatically
heat up using the maximum power and will then switch back to the
cooking level selected by you. The boost time depends on the selected
cooking level (level 1 to 8).
Switching on
1. Place the pan in the middle of a cooking zone.
2. Press the On/Off button (01).
A single beep sounds.
3. Press the display of the desired cooking zone.
A single beep sounds. The indicator directly below the corresponding
display will light up.
4. Slide your finger over the slide control (02) to set the desired setting.
Hold the slide control for at least 3 seconds at the desired level.
An 'A' will appear in the display alternating with the selected
cooking level.