Pan Detection; Residual Warmth Indicator; Boost; Automatic Heat-Up Function - Pelgrim IDK862ONY Notice D'utilisation

OPERATION

Pan detection

Residual warmth indicator

Boost

Automatic heat-up function

EN 8
If the hob does not detect a (ferrous) pan after the cooking power has
been set, the pan detection symbol and the selected power setting will
flash alternately in the display and the hob will remain cold. If a (ferrous)
pan is not placed on the cooking zone within 1 minute, the cooking
zone will automatically switch off (see also 'Pans').
A cooking zone that has been used intensively will retain heat for
several minutes after it has been switched off. An 'H.' appears in the
display as long as the cooking zone is hot.
The 'Boost' function is used to cook at maximum power for a short
period of time (maximum 10 minutes). The power is reduced to setting 9
at the end of the maximum boost time.
Boost function is not available in bridge mode!
Switching on the boost function
The hob is switched on and a pan is on a cooking zone.
• Touch and slide your finger (to the right) over the multi slider of the
desired cooking zone to choose the boost setting. (You can also
use the multi slider if the power has already been set).
The display shows 'P.'. The boost function is immediately active.
Switching off the boost function
The boost function is switched on, the display shows 'P.'.
• Touch and slide your finger (to the left) over the multi slider of the
desired cooking zone to set a lower level.
Or:
• Directly select a lower setting by touching the left side of the multi
slider of the desired cooking zone.
The automatic heat-up function temporarily increases the power
(setting '9.') to heat the contents of the pan. This function is available in
settings 1-8.