Publicité
Les langues disponibles
Les langues disponibles
6
GUIDELINES FOR OPERATION
The unit has been designed for long-term use. To ensure sustainable
performance, please adhere to the following:
Before use make sure that you have mounted and adjusted the unit according
to the instructions of the section 8 "Operation".
Store with the lens cap on in the carrying case.
Switch off the unit after use.
Attempts to disassemble or repair the unit will void the warranty!
The unit is designed for use in various operating temperatures. However, if it
has been brought indoors from cold temperatures, do not turn it on for 2 to 3
hours. This will prevent external optical surfaces from condensation.
To ensure reliable performance, it is recommended to carry out regular
technical inspections of the unit.
WARNING! Do not point the objective lens of the unit at intensive
sources of light such device emitting laser radiation or the sun.
This may render the electronic components inoperative. The
warranty does not cover damage caused by improper operation.
7
BATTERY INSTALLATION
Turn the battery compartment knob (6)
counterclockwise until stop and remove it.
Install two CR123A batteries according to the
marking on the battery compartment cover and
inside it.
Replace the battery cover and press it until its
clicking position - make sure the cover is
closed on both sides.
Battery charge level is displayed on the status
bar (
).
In case of complete battery discharge, icon
flashing on the status bar.
Warning: do not use rechargeable batteries since their use causes
inaccurate battery level indication and and possible disconnection during
operation.
Note: please do not use batteries of different types or batteries with
various charge levels.
6
Open:
is
Fig.2
8
EXTERNAL POWER SUPPLY
The supplied external power adapter allows you to use the following as
external power supply:
- power bank (output voltage 5V, USB plug) or
- EPS3I or EPS5 Battery Pack (output voltage 12V; 2.1 mm plug).
How to connect:
Open and remove the battery compartment cover (see section 7).
Install the external power adapter into the monocular's battery
compartment (see Fig. 3). Make sure that the adapter's latches (C)
have snapped on both sides.
Secure the cover (6) on the adapter (see Fig. 3).
Connect your power bank to the USB port (5V) or your EPS3I/EPS5
battery Pack to the external power jack (12V).
Power the unit on with a short press of the "ON/OFF" (9) button.
To remove the external power adapter, push the latches on both
sides and pull it.
Note. When using your own external power supply, central pin of the
power supply that you connect to the "power" jack of the unit, must have
marking "+".
The power supply or the plug may have marking
Warning! When the unit operates on external power supply, the low
battery indicator (icon
) does not show the actual battery charge
level.
6
5V
C
12V
Fig. 3
7
Publicité
