Pulsar CORE FXQ50 Mode D'emploi page 10

While holding the reticle in the aiming point, move the auxiliary cross to the
point of impact with buttons "LEFT" or "RIGHT" (or RC buttons (22),(24). To
switch movement direction from horizontal to vertical, press button "MODE"
or (23) RC button. Horizontal/vertical travel range of the auxiliary cross
relative to the limiting frame is +/-10.
Eventually the auxiliary cross should match the point of impact, with the
sight's reticle being held in the aiming point.
To save display calibration parameters, keep the "MODE" button (or (23)
RC button) pressed for two seconds - display will show "OK" message; the
image of the target centre should now coincide with the centre of the of
sight's reticle.
To restore factory settings, select "Yes" in the item
Parameters as follows are restored to factory settings:
Operating mode – "Forest";
Brightness of menu symbols – 5;
Magnification – x1;
Brightness settings – 10;
Image calibration mode – automatic;
Display calibration – coordinates X=0, Y=0;
Color inversion - off;
Contrast settings – 6.
Note. Auxiliary menu items ("Display calibration" and "Default settings")
are only available when the unit is in attachment mode.
16
"Default settings".
NOTES
17