Using For The Rst Time - Wolf Garten Lycos 40/370 M Mode D'emploi

Using for the first time
Push the threaded pin
lever , so that the hole is visible. Hold this
tightly with nger and thumb and screw in the
quick-release lever together with the threaded
pin in a clockwise direction until there is a gap of
approximately 10 mm
/ .
Put the anti-kink protector
side of the handle, together with screw
must be inserted into the respective hole
Position the washer
other side .
Push the threaded pin
lever , so that the hole is visible
this tightly with nger and thumb and screw in the
quick-release lever together with the threaded pin
in a clockwise direction
approximately 10 mm
Fasten the upper part of the handlebar, by folding
down the left and right quick-release levers
Note
Depending on our height, ou can select an
operating position for comfortable mow-
ing I/II/III b releasing the two bottom
quic -release le ers
inclination of the assembled handle until
the desired height is obtained
the handle is set to the desired height, snap
the bottom quic -release le ers bac up
again .
To secure the power cable to the lawnmower, lead
it through the open lugs of the
anti-kink protector
cable clip at the indicated point on the
handle .
Note
To simplif transport and storage, ou can
fold the handle together. See Transport and
storage for more detailed information.
Assembling the grass collector (Fig.
Grip the frame with one hand on the handle
and use the other hand to pull the fabric collection
bag over the long end of the frame
the fabric collection bag through with its pro le
section under the handle and attach the pro le
section of the bag to the frame under the handle
.
Then fasten the side pro le sections of the bag on
to the frame, see
Then turn the grass collector upside down and
attach the pro le sections, see
into the quick-release
in place at the right
which
on the screw from the
into the quick-release
. Hold
until there is a gap of
.
and changing the
. Once
and attach it with the
. Guide
- .
- .

Using for the rst time

Supplementary documentation
Make sure the supplied instruction
manuals of the charger and the power
pack are available. Please read and
understand them before putting the
lawnmower into use.
.
Safety function (Fig.
Note
The lawnmower is pro ided with a safet
circuit to pre ent unauthorised use.
Risk of injuries or material damage.
Insert the safety key
.
prior to use.
Always remove the safety key when
work with the lawnmower is interrupted
or nished.
2-position engagement device (Fig.
2 positions are available to prepare the power pack
for use or for storage and transport.
Position 1
The power pack is prepared for storage and
transport.
• The electric contacts are open to prevent the
power pack from self-discharging during stor-
age.
Position 2
The power pack is in operating mode.
• The electrical contacts are closed and the de-
vice is ready for use.
) Power pack charging
Risk of injuries or material damage.
Charge the power pack using the
charger approved by the manufacturer.
The designations of the approved
chargers are listed in the enclosed CE
Declaration of Conformity.
The power pack is supplied partially charged.
Before rst use, fully charge the power pack to
ensure full capacity of the power pack.
Power pack charging must be carried out ac-
cording to the instructions in the supplementary
documentation.
)
WARNING!
immediately
WARNING!
Attention!
EN
)
25