Charging The Battery - Wolf Garten HYBRID POWER 37 Mode D'emploi

Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the mo-
tor is switched off and the cutting tool has come to a stand-
still.
Do not attach the collection bag until your feet are at a
safe distance from the cutting tool.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
Emptying of Grassbox
When the collection bag is full, the flap lowers by itself
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Switch off the motor and remove the contact key.
Empty collection bag.
Remove potential blockages in the cutting space before
starting.
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
Mulch
„Mulching" is a process in which the grass is finely chopped by a
special cutting system and then deposited on the ground. The re-
sult is that the grass does not have to be collected and disposed
of. „Mulching" also prevents the lawn from drying out.
3
Instructions for mulching
We recommend:
Depending on the growth of grass, mulch 1 – 2 x per
week
The grass should not be too high nor too wet!
Go slow while mulching
Take care that the blade channels do overlap.
Do not cut grass more than 20 mm.
3
Note:
Mulching is not advisable in case of moss-affected or
entangled grass, because the cut material stays on the
moss surface and/or entanglement and thus cannot be
absorbed by the ground.
Regularly scarify and manure the lawn.
Activating the mulch function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not start the motor until your feet are at a safe dis-
tance from the cutting tool.
1. Remove the grass collecting bag.
2. Set the switch to „MULCH".
3. Start the motor.
G
K
L
J

Charging the battery

3
General charging instructions
To prolong the service life of the battery, observe the
following instructions:
Charge the battery before using the mower for the first
time.
For charging times, see page 13.
If the battery voltage is too low, the lawnmower switches
off automatically. In such a case, recharge the battery.
The Lithium iron battery must also be recharged before
prolonged periods of non-use, for example at the
beginning of winter.
The Lithium ion battery can be recharged at any charge
M
.
level, and charging can be interrupted and resumed
without any damage to the battery (no memory effect).
External charger
1
Caution! The charger must only be operated in dry
rooms!
1. Remove the contact key
2. Release the battery cover by pushing it down
3. Remove the battery from the recess
4. Connect the battery to the charger
5. Connect the charger to the mains socket (230 V
3
Instructions for the handling of the external charger:
Red LED is on: Battery is being charged
Green LED is on: Charge process completed
If the charger is connected to a power socket without a
battery, the LEDs are off.
In order to prolong the life the battery, it should not be
charged for a period longer than two days.
Integrated quick-charge system
1
Caution! Charge the battery only in a dry environment!
1. Remove the contact key
2. Connect the mains cable to the mains power connection of the
lawnmower
3. Connect the mains cable to the mains socket (230 V
3
Instructions regarding the charge status indicators:
.
F
O
.
P
.
F
.
F
Green LED is on:
Battery capacity =
–
Yellow LED is on:
Battery capacity =
–
Red LED flashing (battery nearly flat):
Battery capacity =
–
The battery should be recharged
–
Red LED is continuously on (device switches
off):
Battery capacity =
–
or
fault (e.g. battery too hot)
–
.
N
.
) .
~
P
~ ).
17