Royal Catering RCBS-1650 Manuel D'utilisation page 6

I. PRECAUTIONS
1. All instructions included in this manual must be read attentively with special res-
pect to the parts regarding safety.
2. This device may be damaged when dropped or hit, so pay close attention during
handling, installation and/or transport.
3. When connecting the device to the power source, always make sure that the
main parameters are the same as indicated on the techplate. Always make sure
that the main is equipped with a residual current device according to the existing
legislation and safety regulations. Connection must be done by qualified staff.
4. It is forbidden to interfere (remove, bypass, etc.) with any safety devices imple-
mented in the device.
5. This instruction manual should be read thoroughly by the operator. Operator
should pay special attention to the parts which concern safety issues.
6. It is forbidden to use the device for any purpose other than it was designed for.
Inappropriate use of the device may be dangerous for your health and may cause
injuries.
7. All actions connected with the installation of the device or power connection of
the device must be done by qualified experienced staff only.
8. It is forbidden to use the device with damaged power wires. After finding such
damage, the device must be switched off and the qualified staff must be notified
in order to replace the damaged parts.
9. Always switch off the power and unplug the power socket when cleaning and
maintenance.
10. Depending on the type of food processed, the device must be cleaned regularly –
in most cases after every use.
11. In order to avoid contamination and to keep hygiene, all parts of the device and
surroundings which are in contact with food, must be cleaned precisely.
12. It is forbidden to clean the device with corrosive or flammable detergents. It is
strictly recommended to use only cleaning products that are safe for food.
13. Electric parts of the device may be damaged when cleaned with water jet.
14. Clean and dry the device if it is not used for a long period of time, also unplug
the power socket.
15. Package materials as well as electrical and electronic parts of the device should
be disposed in accordance with local legislation.
16. During work the device and the power plug must be protected against contact
with water or hot items. When disconnecting the device it is forbidden to pull
the cord; always pull the plug out of the socket.
10
17. It is forbidden to:
• Open the cover of the device.
• Placing objects in the device housing.
• Using the device with wet hands.
• Self-repairing of the device.
• Usage of the device by persons with reduced physical or mental ability, children
and people with no experience or knowledge.
18. The device must be kept away from the children.
19. In order to prevent injuries, when performing maintenance work always proceed
with caution.
20. When performing work, in order to maintain the device in good condition and
during the cleaning of the device, always proceed with caution and always be awa-
re of the risks. This will avoid accidents. Always then unplug the device from the
power source.
II. TECHNICAL DETAILS
Model
Cutting width
The length of the cutting edge
Power / Voltage
Cutting height
III. DESCRIPTION OF THE DEVICE
Rev. 20.03.2017 Rev. 20.03.2017
RCBS-1650 Bone Saw 1650 mm
3 – 180 mm
1650mm
750W / 230 V
about 21,5cm
11