Isolating Detector Zones - Bosch IUI-UEZ-BE1000s Manuel D'utilisation

Operation in the menu

Isolating detector zones

Description
This function makes it possible to isolate one
detector zone or multiple detector zones be-
fore the system is armed. Areas of disarmed
detector zones can be entered if the system
is armed, without an alarm being triggered.
Not in compliance with VdS.
Procedure
1. To call up "ISOLATE ZONES" from the
menu, see chapter "Calling up and ending
functions".
06: ISOLATE ZONES
2. Call up detector zone.
By pressing the "ENTER" key, the first de-
tector zone that can be isolated and its
status (ON/OFF) will be displayed.
ZO 0001 = ON
v
3. Call up additional detector zones.
By scrolling with the
entry of the address using the number pad,
additional detectors zones that can be iso-
lated are displayed.
ZO 0002 = ON
v
keys or by direct
- 18 -
4. Initiate isolation procedure.
Once the detector zone to be isolated has
been called up, the isolation procedure is
initiated by pressing the center
ZO 0002 = ON
ON v OFF
5. Isolate detector zone.
To isolated detector zone 2, press the right
key. After isolation has been com-
pleted, the new status of the detector zone
(= OFF) will be displayed.
ZO 0002 = OFF
v
6. Reset.
The "STOP" key causes a return by one
level. The menu will be displayed.
06: ISOLATE ZONES
key.