Resetting The Control Panel; Resetting Internal Messages - Bosch IUI-UEZ-BE1000s Manuel D'utilisation

Operation in the menu

Resetting the control panel

Description
To switch the system back into standby mode
after messages have come in, the messages
must be reset. Then the system can be re-
armed. To perform a reset, the areas must be
switched to disarmed.
Procedure
1. To call up the "TOTAL RESET" function
from the menu see chapter "Calling up and
ending functions".
02: TOTAL RESET
2. Call up "TOTAL RESET".
By pressing the "ENTER" key, the "TOTAL
RESET" display appears.
TOTAL RESET ?
RESET
3. Execute "TOTAL RESET".
After pressing the center
gering for the control panel are reset.
The messages disappear from the display
as soon as all detectors are in normal con-
dition. If the message type cannot be reset
by the authorized user, 24-hour service
must be informed.
02: TOTAL RESET

Resetting internal messages

Description
All triggered internal messages are reset.
Procedure
1. To call up the "INTERN. RESET" function
2. Call up "INTERN. RESET".
3. Execute "INTERN RESET".
key, all trig-
- 15 -
from the menu, see chapter "Calling up and
ending functions".
03: INTERN. RESET
By pressing the "ENTER" key, the "Internal
reset" display appears.
INTERN. RESET ?
RESET
By pressing the center
gered internal messages
The corresponding message type is de-
leted in the display as soon as all reset de-
tectors are restored to normal condition.
03: INTERN. RESET
key, all trig-
are reset.