Starting And Ending Code Mode With Messages Present - Bosch IUI-UEZ-BE1000s Manuel D'utilisation

Code mode
Starting and ending code mode with
messages present
Description
Inputting the user code grants control au-
thorization level 1 for basic operation or con-
trol authorization level 2 for all operations.
The user code is divided up into the following
areas:
- ID (1 – 3 digits)
- Password (0 – 6 digits)
The password can be changed on the control
panel's operating panel.
Procedure
1. For example, 3 intrusion messages are
displayed.
03 INTRUS. EXT
Menu
2. Start code input. Press the center
"menu" key.
The code input display will appear.
ID:0 CO:
AREA PROG.
3. Enter the user code.
Enter ID (1 to 3 digits) for ID 2, e.g. en-
ter 002. Enter password (0 to 6 digits),
e.g. 123123.
ID: 002 CO:
_ _ _ _ _ _
AREA PROG.
4. Start code mode.
If the user code has been entered correctly
and confirmed with the "ENTER" key for a
code of < 6 digits, any activated sirens will
be switched off and the first function will be
displayed in the menu.
01: INTERN. PROG.
5. Call up the message display in code mode
once again.
After the "STOP" key has been pressed,
the message is displayed without ending
code mode.
03 INTRUS. EXT.
Menu
6. End code mode.
Call up the "STOP CODEOPERATION"
function in the menu and confirm with the
"ENTER" key. (Also see chapter "Calling
up and ending functions".) The code mode
will be exited once again.
03 INTRUS. EXT.
Menu
- 12 -