Code Mode; Starting And Ending Code Mode - Bosch IUI-UEZ-BE1000s Manuel D'utilisation

Code mode

Starting and ending code mode

Description
Inputting the user code grants control au-
thorization level 1 for basic operation or con-
trol authorization level 2 for all operations.
The user code is divided up into the following
areas:
- ID (1 – 3 digits)
- Password (0 – 6 digits)
The password can be changed on the control
panel's operating panel.
Procedure
1. The standby status of the system will be
displayed.
15 : 13 22.11.2005
MENU
2. Starting code input. Press the center
key.
The code input display will appear.
ID:0 CO:
AREA PROG.
3. Enter the user code.
Enter ID (1 to 3 digits) for ID 2, e.g. en-
ter 002. Enter password (0 to 6 digits),
e.g. 123123
ID: 002 CO:
_ _ _ _ _ _
AREA PROG.
4. Start code mode.
If the user code has been entered correctly
and confirmed with the "ENTER" key with a
code of < 6 digits, the first function will be
displayed in the menu.
If no key is pressed for one minute, the
standby picture for the menu or the current
message with the highest priority is dis-
played. If no input is made for 15 minutes,
code mode ends automatically.
01: INTERN. PROG.
5. End code mode.
Call up the "STOP CODEOPERATION"
function in the menu, and confirm with the
"ENTER" key (also see chapter "Calling up
and ending functions"). The code mode will
be exited once again.
15 : 13 22.11.2005
MENU
- 11 -