Troubleshooting - Stiga BC 48 Li Manuel D'utilisation

7. TROUBLESHOOTING

Problem
1. String will not advance
using the auto-feed head.
2. Grass wraps around shaft housing
and string head.
3. Motor fails to start when switch
trigger is depressed
ATTACHEMENTS ON REQUEST
Batteries
batteries of different capacities to fit the
specific operating needs are available.
The list of approved batteries for this
machine is in the table "Technical Data
Possible cause
when String is welded to itself..
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
Lubricate with silicone spray.
Install more string, refer to string
replacement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in
this manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Charger the battery pack according
to the instructions included with you
model.
Make sure lower shaft is fully seated
in shaft coupler on upper shaft and
secure shaft coupler.
10
Solution