Adjusting The Back Angle And Back Depth; After Installation - Invacare Matrx MX1 Mode D'emploi

4 DUAL MOUNT
4.9

Adjusting the Back Angle and Back Depth

1. Loosen the screws A on the side of both clamp bodies B.
2. Adjust the angle adjustable brackets C in the clamp bodies to
achieve the desired back angle and back depth.
 Angle and depth adjustments must be made equally on
both sides.
3. Tighten the screws on both clamp bodies to secure the back into
position.
B
C
A
Invacare® Matrx® MX1

4.10 After Installation

1. Verify that all mounting hardware is fully tightened.
2. Ensure that the back is securely attached to the wheelchair.
18
Part No. 1176090