Installing The Band Clamps; Installing The Back - Invacare Matrx MX1 Mode D'emploi

4 DUAL MOUNT
4.6

Installing the Band Clamps

1. Install the two band clamps A onto the back canes B of the
wheelchair.

Allow the band clamps to rest on the rigidizer bar C.
4.7

Installing the Back

1. Align and insert the tabs A on the band clamp B with the slots C
in the clamp body D.
2. Ensure the band clamp is fully inserted into the clamp body.
D
A
C
Invacare® Matrx® MX1
B
C
A
B
3. Loosen the compression bar hardware E, so the clamp body rests
flush against the back cane.
4. Insert the two locking pins F into the clamp body to lock the band
clamp in position.
 The pins should slide into position with little effort. If the
pins are difficult to insert, verify that the band clamp is
properly centered and fully seated inside the slots G of
the clamp body.
5. Ensure both locking pins are fully inserted.
\
E
6. Tighten the compression bar hardware E to hold the locking pins
F in place. Do not fully tighten the hardware at this time.
16
G
F
F
E
Part No. 1176090