Publicité
Les langues disponibles
Les langues disponibles
Power meter
The power meter shows how much power the product
uses during operation.
•
LED lights 4 and 5 show the best performance and
best battery efficiency.
•
LED light 6 on the right side shows maximum power
and the minimum battery efficiency.
Battery state of charge LED
The status of the battery pack is shown until you pull the
trigger. When you release the trigger, the status of the
battery pack is shown again.
The number of LEDs that are on show the current
charge level of the battery pack.
LED lights
Battery status
All Green LEDs
Fully Charged (100% - 76%)
come on
LED 1, 2 and 3
The battery pack is 75% - 51%
come on
charged.
LED 1 and 2
The battery pack is 50% - 26%
come on
charged.
LED 1 comes on The battery pack is 25% - 6%
charged.
LED 1 flashes
The battery pack is 5% - 0% charg-
ed.
Note: If the motor stops and the power LED stays on,
push the button on the battery pack. For possible
TROUBLESHOOTING on page 12 .
solutions, see
Note: When the battery pack is fully discharged, the
motor stops immediately.
Note: The motor automatically stops if the battery pack
or motor controller is too hot during heavy operation. Let
the motor and battery pack cool. The product then
resets.
To operate the grass trimmer
•
Clean the cover of the trimmer head when you
attach a new trimmer line to prevent vibrations.
•
Examine other parts of the trimmer head and clean if
it is necessary.
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
455 - 003 - 20.11.2017
To trim the grass
•
Hold the trimmer head immediately above the
ground at an angle.(Fig. 24 )
•
Do not push the grass trimmer line into the grass.
To cut the grass
1. Make sure that the grass trimmer line is parallel to
the ground when you cut. (Fig. 25 )
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously, it can cause damage to the trimmer
head.
4. Use full throttle when you move the product from
side to side to cut grass. Make sure that the grass
trimmer line is parallel to the ground. (Fig. 26 )
To edge the grass
1. Make sure that the grass trimmer line is vertical to
the ground when you edge. Walk slowly along the
area to be cut.
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously because it can cause damage to the
trimmer head.
4. Use full throttle.
5. Make sure that the trimmer line ejects the cut
material into an area that was cut before.
To use the twist and edge button
The twist and edge button of the product lets the
operator turn the trimmer head. This makes it easier to
edge along walks or driveways.
(Fig. 27 )
1. Push and hold the button while you turn the motor
housing 180 degrees.
2. Release the button to lock the motor housing in edge
mode
MAINTENANCE
Daily maintenance
•
Remove the battery pack. Refer to the operating
instructions of the battery pack for correct
maintenance.
•
Examine the nuts, screws and bolts.
•
Examine the trigger for correct operation.
•
Examine the power button for correct operation.
CAUTION: Always stop the product and
make sure the trimmer head does not move
before you change the mode of cut.
11
Publicité
