Motor Unit With Multifunction Tool Pkga4 - Parkside PKGA 20-Li B1 Traduction Des Instructions D'origine

Motor unit with multi-
function tool PKGA4
Wear a protective mask during
grinding work.
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Ensure that the tool holder (29) is
tightly screwed in to ensure you can
safely mount and use all the sup-
plied tools (30/32/33).
1. Push the lever (27) for tool unlocking
upwards as far as the stop.
2. Place the desired tool (30/32/33) be-
low the tool holder (29) on the arbors
(28). You may need to rotate the un-
locked tool holder (29) as far as need-
ed to allow you to place the desired
tool (30/32/33) onto the arbors (28).
12 different positions are possible.
3. Rotate the tool holder as required until
it is firmly in place.
4. Push the lever (27) for tool unlocking
forwards again. The tool holder is
fixed to the tool.
Attaching/removing sanding
sheet
The delta sanding plate (30) is fitted with
Velcro for rapid attachment of the sanding
sheet.
Attaching sanding sheet
1. Press the sanding sheet (31) evenly
onto the delta sanding plate (30). En-
sure that the holes in the sanding sheet
are placed above the openings in the
sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (31) off
the delta sanding plate (30).
Sanding
• Use a dust extraction system when
sanding with the multi-sander attach-
ment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
Selection of sanding sheet
Grain size P Application
for pre-sanding rough wood
P 60
surfaces
P 80 / 120 for plain sanding
for fine sanding of primed
P 240
and painted surfaces
GB IE
45